Plymouth Valiant V-100 1965 Service – Technical Manual page 613

GLASS 23-43
\ ,
, ' I
\ \
I ,
REGULATOR MOTOR
k l
-
Fig. 93-Regulator Assembly fRear Door-
AP Models)
ner panel by screw and washer assemblies. Support
the glass assembly when removing the regulator. The
roller on the regulator front arm is retained by a
spring nut. Lubricate the outboard side of the r e g
ulator sector gear tooth contact area approximately
Y 2
inch wide along the entire length of the arc and
the studs on the front and rear arms before installing.
Removal
fAR Models) (Fig. 941
(1)
Remove the door trim panel.
(2)
Carefully remove the door watershield.
(3) Remove the door glass stops.
(4)
Disconnect the door glass from the window reg-
(5) Remove the glass front and rear channels.
(6) Remove the regulator attaching screws and
ulator and remove the door glass assembly.
remove the regulator assembly.
Fig. 94-Regulator Assembly fRear Door-
AR Modelsl
Installafion
sembly with lubriplate.
and install the attaching screws.
(1)
Lubricate all moving parts of the regulator as-
(2)
Position the regulator assembly into the door
(3) Install the glass front and rear channels.
(4)
Install the door glass and the glass stops.
( 5 )
Operate the window regulator assembly and test
(6) Install the door water shield.
(7)
Install the trim panel, arm rest, door handle,
for ease of glass movement and alignment.
regulator handle and the lock rod plastic knob.
Removal
fAV
Models)
water shield.
screw.
glass out of the channels.
channel.
straight up.
ula
t
or.
(1)
Remove the door interior trim, hardware and
(2)
Loosen the front run channel lower mounting
(3) Move the run channel forward and slide the
(4)
Remove the regulator arm from the lift bracket
(5) Remove the glass from the door by lifting
(6)
Remove the regulator attaching screws and r e g
Installation
channel.
the retaining screws.
(1) Lubricate the regulator slide of the lower glass
(2)
Position the regulator on inner panel and install
(3) Position the glass into the door frame.
(4)
Position the regulator arm roller into the lift
( 5 )
Position the glass into the glass run channels,
(6) Install the water shield, door interior trim and
bracket channel.
and adjust the door glass.
hardware.
REAR DOOR STATIONARY GLASS
(Sedan and Station Wagon Models)
AV Models)
Removal
and water shield.
(1) Remove the door interior hardware, trim panel
(2)
Lower the vertical sliding glass.
(3) Remove the upper and lower division bar attach-
(4)
Remove the division bar from the door.
( 5 )
Move the stationary glass rearward to disengage
it
from the weatherstrip and remove the glass from
the door.
ing screws (Fig.
95).
Installation
(1) Inspect the condition of the stationary glass