Plymouth Valiant V-100 1965 Service – Technical Manual page 155

STARTING MOTOR-REDUCTION GEAR
8-1 1
RETAINING
THRLisT 62x209
WASHERS
Fig. 9-Removing or Installing the Pinion Shaft
Retainer Ring
(15) Remove the solenoid return spring from the
(16)
Remove the dust cover from the gear hous-
(17) Release the retainer that positions the driven
CAUTION:
The retainer is under tension and a
cloth should
be
placed over the retainer to pre-
vent it from springing away after removal.
(18) Release the retainer ring at the front of the
NOTE: Do
not spread the retainer ring any greater
than the outside diameter of the pinion shaft oth-
erwise the lock ring can be damaged.
(19) Push the pinion shaft towards the rear of the
housing (Fig. 10) and remove the snap ring and thrust
washers, clutch and pinion assembly, with the two
shifter fork nylon actuators as an assembly (Fig.
11).
(20)
Remove the driven gear and friction washer.
well of the solenoid housing moving core.
ing, as shown in Figure 7 .
gear on the pinion shaft (Fig. 8 ) .
pinion shaft (Fig. 9).
PINION-
SHAFT
I
PINION
SHAFT
/
DRIVEN GEAR
Fig. 7 1 -Removing
or
Installing the
Clutch Assembly
X"
MOVING
SHlF
PIN
'ING FORK
Fig. 12-Removing or Installing the Moving Core
r
Fig.
10-Removing the Pinion Shaft
\
THRUST WASHER
/
SHIFTING FORK
62x213
Fig. 73-Removing or Insfallin9 'he Shifting
Fork
Pin