Advertisement
23-58
GLASS
(5) Inspect the regulator arm stud rollers, and the
glass track rollers for damage or excessive wear.
lns tullut ion
(1) Lubricate the glass lower frame regulator arm
roller slots and the track roller slot.
(2) Install the track roller assembly into the track
slot of the lower frame with the spring loop up.
(3) Position the glass assembly into the quarter
panel and install the regulator arm stud rollers into
the glass lower frame slots.
(4)
Position the regulator arm studs into the roll-
ers and install the spring nuts.
(5)
Test the glass operation and adjust as required.
(6)
Install the water shield, trim panel and regulator
handle.
Rernovul
fAV
Models)
(1) Remove the regulator handle, rear seat back,
cushion, trim panel and water shield.
(2) Run the window down and remove the screw
and washer assemblies attaching the glass to the lower
frame assembly.
(3) Run the window up to approximately 3 inches
below the belt line and remove the glass from the
quarter panel.
lns tullution
(1) Apply lubricant to the regulator arm sliding
surfaces of the pivot bracket.
(2) Run the window lower frame up to approximate-
ly three inches below the belt line.
(3) Position the glass into the quarter panel and
seat the glass in the glass lower frame.
(4)
Run the glass and frame assembly down and
align the holes in the glass with the holes in the low-
er frame.
(5) Install the retaining screw and washer assem-
blies.
(6)
Operate the window and inspect alignment and
operation.
(7) Install the water shield, trim panel, rear seat
back, cushion and quarter window regulator handle.
Regulutor Assembly
The regulators (Fig. 127) are attached to the quar-
ter inside panel with screw and washer assemblies.
When installing a regulator, lubricate the tooth con-
tact area approximately
4 2
inch wide along the entire
length of the arc on the outboard side of the sector
and studs on the front and rear studs.
Front Truck
Rernovul
fAP
Models)
water shield.
(1) Remove the regulator handle, trim panel and
.
R
BRIZNT
#
(ELECTRIC) NK939
Fig. 1 2 7 4 u a r t e r Window
Regulate-
Convertible IAP Models)
(2) Remove the glass and lower frame assembly.
(3) Remove the adjusting stud nut and washers
(4)
Remove the center support nut and washer.
(5) Remove the track upper adjusting stud nut and
washers.
(6)
Remove the track and center support assembly
out of the quarter panel through the large access
opening.
Installation
(1) Position the track and center support assembly
into the quarter panel through the large access open-
ing and insert the studs into the openings in the inner
panel (Fig. 128).
(2) Install the track upper adjusting stud nut and
washers finger tight only.
(3) Install the center support nut and washer finger
tight only.
(4)
Install the track lower adjusting stud nut and
washers finger tight only.
(5) Install the quarter glass and frame assembly.
(6)
Adjust the quarter glass and test the operation
from the lower end of the track (Fig. 128).
of the glass for ease of movement.
\
NK946
SCREW
AND
WASHER
' T i
SUPPORT
Fig. 1 2 8 4 u a r t e r Window Front rrack-
Convertible IAP Models)
Hide quick links:
Advertisement
