Plymouth Valiant V-100 1965 Service – Technical Manual page 587

INTERIOR TRIM AND SEATS 23-17
FRONT TO REAR
UP AND DOWN TILT
SIX ADJUSTMENTS
STATIONARY SUPPORT PLAT
2-WAY SEAT TRACK
ADJUSTING BOLT
SUPPORT PLATE
NY
1337
Fig. 27-Console Trim Carpets
(3) Lift the sides of the floor tunnel carpets, on the
console (Fig.
27)
to expose the slots in the body of the
console.
(4)
Loosen the screws, (six used for automatic trans-
missions and five for manual transmission consoles).
(5) Lift the console off the screws and disconnect
the backup lights, tachometer and body wires from
their connectors.
(6)
Guide the console over the transmission shift
lever and remove.
lnstalla tion
(1) Guide the console over the shift lever and con-
nect the backup lights, tachometer and body wires to
their respective connectors.
(2) Lift the sides of the carpets on the console to
expose the slots in the console (Fig.
26)
and position
the console on the mounting screws.
(3) Tighten the screws securely and install the two
screws and washers attaching the console to the floor
brackets.
Carpet Replacement
The carpet assemblies are attached to the console
by trim fasteners and cement (Fig.
27).
The carpet
CEMENT
I \
I
d NK850
Fig. 28-Console Side Trim Carpet
Fig. 29-Six W a y Seat Adjustment
on
the console side cover (Fig.
28)
is pre-formed. Ap-
ply cement to both the inside of the cover carpet
and to the mating surface of the cover. Cement
should only be applied to the unsupported portions of
the console carpets and to the mating surfaces of the
console (Fig.
27).
SEATS-MANUALLY ADJUSTED
Refer to the Electrical Group 8 for the service pro-
cedures of the Power Seats.
Front Seat AdjustmentAAR and AP Models)
The horizontal slots (Fig.
29)
allow a fore or aft
movement of 1%
inches. The vertical slots allow
up or down or tilt movement of
1%
inches.
Loosen the four adjusting bolts (two in each seat
base) and after positioning the seat as desired, tight-
en the bolts to lock it in place. Each seat track is at-
tached to the seat base by two studs and nuts.
Front Seat Adjustment4AV Models)
The manually operated individual front seats used
on AV Models are adjustable the same as AR and
AP Models.
All
other
AV
Models with manually oper-
ated front seats allow only fore and aft adjustment.
To obtain additional front seat height, proceed as
follows:
(1) Remove the nuts attaching the seat tracks to
the floor pan.