Advertisement
TRANSMISSION-TORQUEFLITE
2 1-83
THROTTLE LEVER AND SHAFT
MANUAL VALVE
GOVERNOR PLUG
END PLATE
NK 1,y,
Fig. 74-Valve
Body
Controls
(Assembled View1
larger chamber (Fig. 73). Remove the steel balls, front
pump check valve and spring.
(9)
Invert the valve body and lay it on a clean cloth
or paper. Remove E-clip from the throttle lever shaft
(Fig. 74). Remove any burrs from the shaft, then
while holding the manual lever detent ball and spring
in their bore with Tool C-3765 or similar tool, slide
the manual lever off the throttle shaft. Remove the
detent ball and spring.
(10) Remove the manual valve, carefully slide it
out of valve body with a rotating motion.
(11) Remove the throttle lever and shaft from the
valve body.
(12) Remove the shuttle valve cover plate (Fig. 74).
Remove the E-clip from the exposed end of the shut-
tle valve.
(13) Remove the throttle lever stop screw assem-
bly (Fig. 75), be careful not to disturb the setting any
more than is necessary.
(14) Remove the kickdown detent, kickdown valve,
throttle valve spring and the throttle valve (Fig. 75).
(15) Remove the governor plug end plate (Fig.
75).
Tip up the valve body to allow the shuttle valve throt-
tle plug, spring, shuttle valve, and the shift valve gov-
ernor plugs to slide out into your hand.
Note the longer stem on the 1-2 shift valve plug as
a means for identification.
(16) Remove the shift valve end plate (Fig. 76) and
slide out the two springs and valves.
(17) Remove the regulator valve end plate. Slide
the regulator valve line pressure plug, sleeve, and the
regulator valve throttle pressure plug out of the
valve body.
Cleaning
and
Inspection
Allow all parts to soak a few minutes
in
a suitable
clean solvent. Wash thoroughly and blow dry with
compressed air. Make sure all the passages are clean
and free from obstructions.
TORQUE CONVERTER
2-3
SHIFT VALVE GOVERNOR PLUG
/
SHUTTLE VALVE
THROTTLE PLUG
N K 167
Fig. 75-Valve
Body-lever
Side IDisassembledl
Hide quick links:
Advertisement
