Advertisement
23-16
INTERIOR T R I M AND SEATS
Remove the front and rear window garnish mould-
ings. Starting at either end, pry the plastic moulding
from the retainer, using a screwdriver. Pull down on
the moulding to release it from the retainer. Remove
the damaged section by pulling downward on the
damaged section to release
it
from the retainer (Fig.
22).
To remove the headlining at the side, pull towards
the center of the car and this will release the head-
lining from the small spring type clips at the outer
edges.
To install the side pieces of the headlining push the
headlining onto the small retainers at the sides of
the car. Push the headlining up at the center and
properly center the moulding and snap into place.
If the center section is to be installed push it into
place on the retainers and snap the mouldings onto
the retainers and install the garnish mouldings.
Poly Foam Headlining
The removal and installation procedures for poly
foam headlining are the same as those for the hard
board headlining. When installing the poly foam
headlining make certain all wrinkles are removed be-
fore installing the retainer mouldings.
INSTRUMENT PANEL T R I M P A D
The instrument panel trim pads (Figs. 23,
24
and
25)
are attached to the instrument panel with clip and
stud type fasteners.
CONSOLE
Removal
(1)
Raise the console lid and remove the two screws
and washers attaching
ets.
(2)
On manual floor
the screw and washer,
and access hole in the
(Section B-B).
the console to the floor brack-
mounted transmissions, loosen
left side only, through the slit
carpet on the console (Fig.
26)
SECTION A-A
SECTION
B-B
NK1144
Fig. 2 3 4 n s t r u m e n t Panel Trim Pads
IAP Models)
, R E T A I N E R
S C R E W
\MOULDINGS/
NK830
Fig. 2 A n s t r u m e n t Panel Trim Pads
IAR
Models)
NUT
b .
Fig. 2 5 4 n s t r u m e n t Panel Trim Pads
IAV
Models)
-
T O FRONT O F
CAR
Fig. 26-Console
Side Mounting Brackets
Hide quick links:
Advertisement
