Plymouth Valiant V-100 1965 Service – Technical Manual page 623

GLASS 23-53
Fig. 1 14-Quarter Window Adiustments-
Hard l o p (AV Models)
the front door glass, the top of the quarter glass
is
flush with the top of the front door glass and parallel
to the roof rail weatherstrip.
(6) Adjust the up stop down against the regulator
arm.
(7) Run the window down
so
the top of the glass
is even with or slightly below the belt line of the out-
side panel.
( 8 )
Adjust the stop on the regulator plate against
the stop on the regulator sector.
(9) Operate the window and inspect alignment
and ease of operation.
(10) Install the water shield, trim panel and hard-
ware.
Fig.
I
I 5 4 u a r t e r Window Adiustments-
Hard l o p IAVP29 Models1
ROLLER TRAC
SPRING NUT
CIRCLES
-
A
Fig.
I I
& - Q u a r t e r Window Replacement-
Hard l o p IAP Models)
Quarter Glass Replacement
Removal
fAP
Models)
watershield.
lower frame (Fig. 116).
studs.
regulator studs from the roller assemblies.
in the glass lower frame.
from the quarter panel.
Installation
(1) Inspect the front and rear track roller assem-
blies for damage or excessive wear.
(2)
Apply lubricant to the regulator arm roller slots,
track slide roller slot and bracket and roller assembly
slot in the glass lower frame.
(3) Position the window assembly into the quar-
ter
panel, engaging the track roller assemblies.
(4)
Insert the regulator arm rollers in the glass
lower frame slots and position the regulator arm studs
into the rollers, securing in place with spring nuts
(Fig. 116).
(5) Install the down stop assembly on the glass low-
er frame.
(6) Adjust the window assembly for alignment and
ease of operation.
(7) Install the water shield, trim panel and regulator
handle.
(1) Remove the regulator handle, trim panel and
(2) Remove the down stop assembly from the glass
(3) Remove the spring nuts from the regulator arm
(4) Support the window assembly and remove the
(5) Remove the rollers from the regulator arm slots
(6) Remove the glass and lower frame assembly