Plymouth Valiant V-100 1965 Service – Technical Manual page 36

LUBRICATION 0-29
Fig. 76-Throttle Linkage-Lubrication Points lModels AP-21
at both upper and lower ends of transmission linkage
and the clipped end of transmission linkage bearing
areas.
Throttle Linkage Lubrication-AR- I Models
Apply a thin film of Automative Multi-Purpose
Grease, NLGI Grade
2,
to both ends of the accelerator
shaft where it turns in the bracket and where the
nylon roller rolls on it (Fig. 72). Also, apply a thin film
of the same lubricant to the engine mounted bellcrank
pin.
Throttle Linkage Lubrication-A
R-2
Models
Apply a thin film of Automotive Multi-Purpose
Grease, NLGI Grade 2, to both ends of the accelerator
shaft where it turns in the bracket and where the
nylon roller rolls on it (Figs. 73 and 74).
Throttle Linkage Lubrication-AP
-
I Models
Apply a thin film of Automotive Multi-Purpose
Grease, NLGI Grade 2, to both ends of the accelerator
shaft where it turns in the bracket and where the
nylon roller rolls on it (Fig. 75). Also, apply a thin
film of the same lubricant to the engine mounted
bellcrank pin.
Throttle Linkage Lubrication-AP-2 Models
Apply a thin film of Automotive Multi-Purpose
Grease, NLGI Grade
2,
to both ends of the accelerator
shaft where it turns in the bracket and where the
nylon roller rolls on it (Fig. 76). On models with auto-
N K658
Fig. 77-Fuel Tank Filler Door Lubrication
matic transmission, also, apply a thin film of the same
lubricant to the roller where it contacts the underside
of the pedal, to the pivot points of both.upper and
lower transmission linkage bellcranks and clipped
ends of transmission linkage rod bearing areas.
Fuel Tank Filler Door-AP-I, AP-2 Models
Apply a thin film of Automotive Multi-Purpose
Grease, NLGI grade 2, to inside surface of spring
ends (Fig. 77).
License Plate Mounting Panel Springs and
Pin-A R- I , A
R-2
Models
Apply a thin film of Automotive Multi-Purpose Lu-
bricant NLGI grade 2, to the panel springs and pin.