Advertisement
23-46
GLASS
the division channel is established.
The fore-or-aft adjustment at the lower end of the
division channel removes binding or looseness of
the glass when in the lowered position.
The lower end of the lower rear channel can be
adjusted in or out to align
it
with the division chan-
nel. Both attaching screws at the lower end of the
rear channel must be loosened to make this adjust-
ment. If the glass binds at the belt line, the upper
end of the rear channel can be adjusted in or out to
enter the glass between the inner and outer cat
whiskers.
Glass
Replacement
Vent Wing and Door
Glass fAP
Models)
To remove the vent wing glass or weatherstrip after
the vent wing has been removed, it is necessary to
first remove the swivel assembly (Fig. 101).
Removal
inside handles, trim panel and water shield.
the lower end of the vent wing leg (Fig. 101).
taching the vent wing to the belt line.
the hinge pillar support.
(1)
Lower the window fully and remove the door
(2) Remove the nut and washer from the stud
on
(3) Remove the screw and washer assemblies at-
(4)
Remove the vent wing leg stud from the slot in
( 5 ) Remove the vent wing swivel to regulator screw.
(6)
Move the door glass forward disengaging
it
from the rear run channel.
(7)
Slide the glass lift bracket off of the regulator
arm and remove the door glass and vent wing assem-
L V
LIFT BRACKET
NK8B5
Fig. 101-Vent
Wing and Door Glass Attachment
-Hard
Top-Convertible fAP Models)
@
DJUSTING
STUD
LIFT BRACKET , & GUIDE
\
-
\
RIVET
NK898
GASKET'
-
Fig. 102-Glass
Lift Bracket fAP Models)
bly from the door.
(8)
Separate the door glass from the vent wing di-
vision bar (Fig. 102).
(9)
Remove the stud from the leg of the vent wing
assembly.
(10) Remove the plastic rivet attaching the lift
bracket to the glass and remove the bracket and gas-
ket.
Installation
glass and install the plastic rivet.
wing assembly.
(1)
Position the lift bracket and gasket on the door
(2)
Assemble the door glass and frame to the vent
(3) Install the adjusting stud to the vent wing leg.
(4)
Lubricate the slide area of the lift bracket guide.
(5) With the regulator in the down position, in-
stall the door glass and vent wing assembly into the
door and position the vent wing pivot swivel into the
regulator assembly.
(6)
Position the glass lift bracket on the regulator
arm and move the glass rearward into the rear run
channel.
(7) Position the adjusting stud on the vent wing
leg into the slot in the hinge pillar support.
(8)
Install the vent wing swivel to the regulator
screw.
(9) Install the vent wing to belt line screw and
washer assemblies.
(10) Install the nut and washer on the vent wing
adjusting stud.
(11) Operate the window and inspect alignment and
test for ease of operation. Adjust as required.
(12) Install the water shield, trim panel and inside
handles.
Vent Wing
Removal
fAR
Models)
(1)
Remove the arm rest, inside handles, remote
Hide quick links:
Advertisement
