Advertisement
SIX WAY POWER SEATS
8-87
SERVICE PROCEDURES
Installation
Fasten the solenoid to the door and connect the
wires. Tighten the solenoid mounting screws finger
tight. Reconnect the lock connecting the rod to the
solenoid. Adjust the solenoid by moving the solenoid
up or down in the slotted holes, so that the solenoid
will push and pull the lever far enough to accomplish
locking and unlocking. Reinstall the trim panel.
SOLENOID
Removal
Remove the door trim panel. Disconnect the lock
to solenoid connecting rod at the solenoid. Discon-
nect the wires and remove solenoid.
S I X - W A Y POWER SEATS
Models AR-7, AR-2,
AP-7
and
AP-2
Description
The power seat can be moved six ways-forward,
back, up, down, tilt forward and tilt rearward. The
horizontal travel is five inches and horizontal plane
of seat track
is
inclined eleven degrees. The vertical
travel is one inch at front and two inches at rear. The
available tilt is
8
degrees forward and 7% degrees
rearward from neutral.
SERVICE PROCEDURES
Operation (Fig.
7 )
The motor operates a gear drive train which sup-
plies power to the slave units, located in the seat
tracks, through flexible cables. The control switch
is
on the left side of front seat and is wired through a
relay to a
30
ampere circuit breaker, located above
the left cowl panel.
The wire from the bulkhead disconnect supplies
power to the circuit breaker.
Power is supplied to the relay from the circuit
breaker.
Six wires go to the switch. One used for power,
two for motor field current, which also actuates the
relay for motor armature current and three wires at-
tach to solenoids controlling the movement of the
front riser, rear riser and horizontal movement.
The right and
left
tracks are each replaced as
an
assembly only. They cannot be adjusted and are not
interchangeable.
Front Seat Assembly and Adjuster
Removal
(1)
Disconnect the battery ground cable.
(2)
Remove the four mounting stud nuts which
hold the front seat to the adjuster and tilt the com-
plete seat back assembly forward.
(3)
Disconnect the switch control wires.
(4)
Remove the front seat and cushion assembly.
(5)
Disconnect the seat adjuster red feed wire.
(6)
Remove the seat guide attaching stud nuts and
remove the adjuster.
Installation
(1)
Install the adjuster and seat guide stud nuts.
(2) Connect the seat adjuster red feed wire.
(3)
Install the front seat assembly.
(4)
Connect the control wires to the switch and
tighten the mounting stud nuts securely.
(5)
Connect the battery ground cable.
Flexible Cables
Removal
(1)
Remove the front seat assembly.
(2) Disconnect the red feed wire.
(3)
Remove the retainer plate that holds the right
side tubes to the drive assembly.
(4)
Remove the left seat guide attaching stud nuts
and remove the guide and the drive assembly (Fig.
2).
NOTE: Be careful not to bend or damage right side
tubes when sliding tubes out of drive assembly.
(5)
Pull the flexible cables from the right side tubes
(6)
Remove the bolts that hold the motor and drive
(Fig.
3).
RIGHT SEAT TRACK ASSEMBLY
MOTOR AND DRIVE UNIT ASSEMBLY
LEFT SEAT TRACK ASSEMBL
63x632A
TO CONTROL &ITCH
- 7
Fig. 1-Power
Seat
Assembly
Hide quick links:
Advertisement
