Advertisement
POWER WINDOWS
8-95
position.
(5) Remove the regulator attaching screws, pivot
arm from the guide on the inner panel and remove
the motor and regulator through the opening in the
door.
(6) If it is
necessary to replace the gear box, remove
the regulator counter-balance spring.
NOTE: Be sure to remove the counter-balance
spring before disassembling the gearbox.
The gear box
is
replaced as an assembly only and
is lubricated at assembly. No further lubrication is
required.
Installation
(1)
Place the motor and regulator through the door
opening and insert the pivot arm into the guide on
the inner panel.
(2)
Install the regulator screws finger tight.
DO
NOT
tighten at this time.
(3)
Remove the window prop and lower the glass.
(4) Insert the control arms into the glass channel,
using a leather washer on each side of the channel
and secure with a clip.
(5)
Connect the wires to the motor and connect
the battery.
(6)
Operate the window several times and stop the
glass halfway.
(7)
Tighten the regulator screws.
(8)
Inspect the glass alignment.
(9)
Connect a test ammeter into the electrical cir-
cuit and operate the window. The ammeter reading
should be constant without fluctuation at approxi-
mately 14 amperes.
If the ammeter reading fluctuates, there
is
a bind
in the glass or in the linkage. The down stop should
be adjusted so that the window is flush with the gar-
nish moulding.
(10)
Install the trim panel, switch and garnish
moulding.
Quarter Glass Regulator
1 2
Door
Hardtopl-Models
AR- 7 and AR-2
NOTE: If the window regulator is jammed in either
the extreme
"UP"
or "DOWN" position it is neces-
sary to remove the "UP" or "DOWN" regulator
stop to allow removal of the window glass.
Removal
(1) Remove the rear seat.
(2)
Remove the trim panel and garnish moulding.
(3)
Run the window down (using the window
lift
switch) until the glass to window frame mounting
screws are opposite the access holes in the inner pan-
el.
(4) Remove the window glass mounting screws and
lift the glass up out of the inner panel.
(5)
Remove the regulator adjusting lock nut.
(6)
Remove the roller track assembly.
(7)
Remove the roller track assembly mounting
(8)
Disconnect the wires to the motor.
(9)
Unhook the lower glass frame from the regula-
(10) Remove the regulator mounting screws.
(11) Remove the regulator assembly out through
bracket.
tor arm.
the access opening in the inner panel.
Installation
(1)
Install the regulator assembly in through the
access opening in the inner panel and install the
mounting screws.
(2)
Hook the lower glass frame to the regulator
arm.
(3)
Install the roller track assembly mounting
bracket.
(4) Install the roller track assembly.
(5)
Install the regulator adjusting lock nut.
(6)
Install the window glass in through the top of
the inner panel.
(7)
Position the window glass to the lower glass
frame and install the window glass mounting screws.
(8)
Connect the wires to the motor.
(9)
Test the operation of the window lift.
(10)
Install the trim panel and garnish moulding.
(11)
Install the rear seat.
Hide quick links:
Advertisement
