Advertisement
ENGINES--.6=CYLINDER
9-7
BUMPER
+
62x272
Fig. &Rear
Engine Mount A V - I , AV-2
tery and the carburetor air cleaner.
move the radiator.
der head cover.
and wiring to the engine.
(3) Remove the radiator and heater hoses and re-
(4) Remove the closed vent system from the cylin-
(5) Disconnect the fuel lines, carburetor linkage
(6) Disconnect the exhaust pipe at the manifold.
(7)
Raise the vehicle on a hoist.
(8) Drain the converter housing and the transmis-
sion. Remove the oil cooler lines, filler tube and shift
cable.
(9) Remove the clutch torque shaft, brake cables
and rods.
3
SPEED AUTOMATIC
TRANSMISSION
3
SPEED MANUAL
TRANSMISSION
Fig. 5-Rear
Engine Mount AP-I
Fig. &Front
Engine Mount A V - I
(10) Remove the speedometer cable and the gear
(11) Disconnect the propeller shaft and tie-up out
(12) Install the engine support fixture Tool (2-3806
(13) Remove the engine rear support crossmember
(14) Remove the transmission bolts from the clutch
(15) Remove the transmission.
(16) Lower the vehicle.
(17) Install the engine lifting fixture Tool C-3804
to the cylinder head and attach a chain hoist to the
fixture eyebolt.
shift rods.
of way.
to support the rear of the engine.
(Figs. 4 and 5 ) .
housing.
(18) Remove the engine support fixture.
(19) Remove the front engine mount bolts (Figs.
(20) Lift the engine from the engine compartment
6 and 7 ) .
and install in an engine repair stand.
Instullution
(1) Install the engine lifting fixture Tool C-3804
Fig. 7-Front
Engine Mount AP-I
Hide quick links:
Advertisement
