Plymouth Valiant V-100 1965 Service – Technical Manual page 104

5-6
B R A K E G S E R V I C E
BRAKE SHOE R E M O V A L
CAUTION: Install cylinder piston clamps, Tool
C-416 to prevent fluid leakage or air entering the
hydraulic system during brake shoe removal.
With the vehicle elevated on a hoist, jack or
suit-
Removing the Front Brake Shoes
able stands, remove the front wheels and drums.
Fig. &Removing
or
Installing the Brake Shoe
Return Springs Ifront)
(1) Using Tool C-3785 remove the brake shoe re-
(2) Remove the brake shoe retainer, spring and
IMPORTANT: Insert a small punch into the center
turn springs, as shown in Figure 4.
pins (Fig. 5 ) .
P P E C I A L TOOL
RETAll
'RING
NK510
Fig. L R e m o v i n g the Brake Shoe Retainers,
Springs and Pins
of the brake shoe to backing plate retainer spring,
and while holding the backing plate retainer clip,
press in and disconnect the spring (Fig. 6).
-
RETAINER CLIP (2)
Fig. &Removing or Installing Brake Shoe
Retainer Spring
(3) Remove the anchor pin plate.
(4)
Remove the primary and secondary brake shoe
assembly from the support. Install wheel cylinder
clamps, Tool C-416 to hold the pistons in the cylinder.
(5)
Overlap the anchor ends of the primary and
secondary brake shoes and remove the adjusting star,
lever, spring, cable and cable guide.
Removing the Rear Brake Shoes
(1) With the vehicle elevated on a hoist, jack
or
suitable stand, remove the rear wheel, and the drum
retaining clips. Remove the drum.
(2) Using Tool C-3785 remove the brake shoe
re-
turn
springs (Fig. 7).
Fig. 7-Removing or Installing Brake Shoe Return
Springs IrearJ