Advertisement
GLASS
23-49
(4)
Move the door glass rearward and engage
it
in
(5)
Tighten the vent wing attaching screws and
(6) Adjust the door glass and vent wing assembly.
(7)
Install the water shield, trim panel and door in-
the
run
channel.
stud nut.
side handles.
Glass Run Channel (Four Door Models)
The front door rear glass run channel used on four
door hard top models is attached to the door face by
screw and washer assemblies (Fig. 106).
REAR DOOR GLASS (Hard
Top)
Adjustments (AP Models)
(1)
From inside car with the trim panel removed,
close the door and run the window up fully, seating
the top of glass against the roof rail weatherstrip and
the front of the glass flush with the top of the front
door glass.
(2) Adjust the lower front track attachment (Fig.
107) so the front of the glass is aligned with the rear
of the front door glass at the roof rail. Turn the ad-
justing sleeve nut counterclockwise to move glass
inboard and clockwise to move glass outboard.
(3) Adjust the pivot bracket so the front edge of
the glass is parallel to the rear edge of the front
door glass.
(4)
Move the upper front track attachment forward
so
the weatherstrip of the window is against the front
door window,
( 5 )
Position the front and rear up stops down
against the lower frame of the glass assembly.
(6) Run the window
Yz
way down and tighten the
lower rear roller track attaching screw.
UP STOP
CENTER SUPPORT
IN AND OUT
I N AND
OUT
I N AND OUT LOCK WASHER
NK916
Fig. 107-Rear
Door Glass Adjustment-
Hard Top
(7)
Run the window down until top of glass is
even with or slightly below the belt line.
(8) Position the stop on the regulator plate against
the stop on the regulator sector and tighten the nut.
(9) Move the down stop on the lower frame down
against the bumper and tighten the screws.
(10) Run the window to the fully up position.
(11) Loosen the center support front track screw
and move the support inboard against the inside pan-
el. Tighten the screw.
(12) Adjust the center rear track until the "boss"
is against the outboard side of the inside panel.
(13) Test the window for ease of operation and in-
spect alignment.
(14) Install the water shield, trim panel and inside
handles.
Glass Replacement
Removal IAP Models)
tershield.
frame (Fig. 108).
studs.
regulator studs from the glass lower frame.
from the door.
excessive wear.
(1)
Remove the inside handles, trim panel and wa-
(2) Remove the down stop from the glass lower
(3) Remove the spring nuts from the regulator arm
(4)
Support the window assembly and remove the
(5)
Remove the glass and lower frame assembly
(6) Inspect the roller assemblies for damage and'
Installation
roller slots in the lower frame of the door glass.
(1)
Lubricate the regulator arm roller and track
TRACK ROLLER
d
&
&
D O W N STOP
/SCREW
AND WASHER
Fig. 1 OB-Rear
Door Glass Replacement-
Hard Top
Hide quick links:
Advertisement
