Advertisement
23-26
ALIGNMENT, HOOD-FENDER
AND DOORS
(5) Install the door interior trim and hardware.
NOTE:
On vehicles with electric window lifts, dis-
connect the battery negative terminal at the bat-
tery, insert the wiring into the door and attach the
wiring to the motor and control switch prior to the
installation of the trim panel.
Hinge Replucement
The door hinges are attached to the doors by screws
accessible from the outside. The front door hinges
are each attached to the "A" post by three screws.
One screw on each side (AV and AR Models) is acces-
sible from the outside, while the two remaining bolts
are reached by removing the kick panel and removing
the screws through the access holes in the inner pan-
el.
The rear door hinges are attached to the "B" post
by three screws accessible from the outside (except
station wagon upper hinge). The lower hinge mount-
ing is covered by a metal shield held to the "B" post
by three metal screws.
On station wagons, the upper hinge is retained to
the "B" post by three screws accessible from under
the post trim panel.
HANDLES
Inside Hundles
retained by allen
set
screws (Fig.
48).
Door Outside Hundle Replacement
(1)
Remove the arm rest, inside handles, escutch-
eons, trim panel and water shield.
(2)
With the door glass in the up position, through
the inner door panel openings, remove the attaching
nut and washer and the attaching screw and washer
from the door handle (Figs.
49
and 50).
(3) Unsnap the ball and socket of the linkage from
the handle and remove the handle from the door.
The inside door and window regulator handles are
LINK
IkHA
W
VIEW IN DIRECTION
OF ARROW Z
'DOOR LOCK
64 x 432
Fig. 49-Door
Outside Handle Attachment
IAR-AV Models1
(4)
Prior to installing the handle, lubricate the
handle with lubriplate.
(5) To install the handle, place the handle in the
door and install the nut and washer and attaching
screw on the handle.
(6) Snap the socket of the linkage onto the ball
of
the handle assembly and test the operation of the
handle.
(7)
Install the water shield, trim panel, inside han-
dles, arm rest and remote control lock knob.
LOCK ASSEMBLY REPLACEMENT
Door Lock Replucement Wig.
51)
(1)
Remove the door trim panel and watershield.
(2)
Disconnect the handle to lock link from the
lock by pulling the link outward at the lock.
(3) Disconnect the locking lever 'rod (front
door
only) from the lock assembly by forcing it out with a
thin blade screwdriver.
WINDOW REGULATOR HANDLE
/
SCREW
4-
% @
REMOTE CONTROL
SCREW
HANDLE
SPACER
64
x 431
Fig. 48-Inside
Handle Attachment
HANDLE
/HANDLE
I
NUT
WASHER/
NUT
a
WASHER/
2
VIEW A
NK879
Fig. 50-Door
Outride Handle Attachment
IA P Modelsj
Hide quick links:
Advertisement
