Plymouth Valiant V-100 1965 Service – Technical Manual page 124

5-26 BRAKES-POWER-MIDLAND ROSS
Assembly
(1) Install the "0" ring on the power piston.
(2) Install the two "0" rings, and seal on the plung-
er assembly.
(3) Install the rear seal into the rear seal retainer
with the lip of the seal toward the small end of the
retainer.
(4) Install the
"0" ring on the outside diameter of
the rear seal retainer.
(5)
Insert the rear seal retainer assembly into the
hub of the rear cover.
(6) Holding the seal retainer in place invert the
cover over a large socket to support the seal retainer
in
place.
\\
RINGS
C L I P
\
" L
RETURN
i
t
Fig. 43-Removing Valve Retainer
(7) Apply downward pressure on the rear cover
and install the retainer ring.
(8) Install the plunger assembly into the valve
body.
(9) Install the valve into the valve body with the
rubber insert contacting the valve seat. Install the
valve return spring over the valve.
f
I
REAR
COVE1
63x349
b
Fig. 45-Rear Seal Assembly
(10) Install the load ring onto the plunger with the
concave face out.
(11) Press downward on the valve body and insert
the spring clip into the groove of the plunger.
(12) Install the reaction ring with the three raised
portions toward the reaction levers (Fig. 42).
(13) Install the levers and fulcrum ring into the
rubber retainer.
(14)
Align the indexing tab with the notch in the
valve body and insert the assembly into the valve
body with the fulcrum ring on the underside.
(15) Install the two plastic rings onto the plunger
shaft.
(16) Install the master cylinder push rod onto the
plunger assembly.
(17) Install the bellows into the bellows retainer
and install the retaining ring onto the bellows.
(18) Place the valve body assembly into
the
detents
of the diaphragm and install the bellows and retainer
assembly.
(19) Install the bellows retainer snap ring.
O-RINGS
n
L I P SEAL
\
V A
B O D Y
I ,
I
PUSH ROD
PLUNGER
A S S E M B L Y
64x289
Fig. 44-Removing or Installing Valve
Fig. 46-Valve Plunger Assembly