Plymouth Valiant V-100 1965 Service – Technical Manual page 51

1-14 RADIO AND ANTENNA
(3) Remove the clock set knob.
(4) Disconnect the wiring from the clock.
(5) Remove the two screws that attach the clock to
the instrument cluster and carefully remove the
clock.
Installation-AR- I , AR-2 Models
install the two attaching screws.
(1) Install the clock into the instrument cluster and
(2) Connect the wiring to the clock.
(3) Install the clock reset knob.
(4)
Install the instrument cluster.
(5) Connect the battery ground cable.
(1) Disconnect the battery ground cable.
Removal-AP- I , AP-2 Models
(2) Remove the radio and heater trim bezel from
(3) Remove the two screws that mount the clock to
(4)
Pull the clock out of the instrument panel and
the front of the instrument panel.
the instrument panel.
disconnect the wiring to the clock.
Installation-AP-I, AP-2 Models
panel opening and connect the wiring to the clock.
stall the two mounting screws.
front of the instrument panel.
(1) Position the clock in front of the instrument
(2) Install the clock in the instrument panel and in-
(3) Install the radio and heater trim bezel on the
(4)
Connect the battery ground cable.
RADIO AND ANTENNA
Description
Available
as
optional equipment on Models AR-1
and AR-2, are AM radio Model 225 and AM-FM radio
Model 361. Available on Models AP-1 and AP-2 are
AM radio Model 225 and AM-FM radio Model
360.
Available on Models AV-1 and AV-2 is AM radio Model
222. All of the available radio models are fully tran-
sistorized.
SERVICE PROCEDURES
RADIO
Removal-AP- I , AP-2 Models (Fig. I
I
NOTE: For vehicles equipped with air condition-
ing, the radio is serviced through the glove
box
opening in the instrument panel.
CAUTION: Do not operate the radio with the
speaker detached since damage to the transistors
may result.
(1)
Disconnect the battery ground cable.
(2) Remove the radio control knobs.
(3) Remove the radio mounting nuts.
(4)
From under the instrument panel disconnect
the speaker leads, radio feed wire and the antenna
lead
cable
at the radio.
(5) Remove the radio to instrument panel mount-
ing bracket and remove the radio.
Removal-AR- I , AR-2 Models Wig.
2 1
NOTE: For vehicles equipped with air conditioning,
the radio is serviced through the glove
box open-
ing in the instrument panel.
(1)
Disconnect the battery ground cable.
(2)
Remove the control knobs from the front of the
radio.
t
I
Fig. I-Radio-AP-1, AP-2 Models Fig. 2-Radio-AR-1
,
AR-2 Models