Advertisement
23-60
GLASS
regulator and run channel attaching screws and nuts.
(2)
With the tail gate open, adjust the upper attach-
ments of the lower run channels
so
the glass lightly
touches the cat whiskers.
(3) From inside the vehicle and with the tail gate
closed, run the glass
Y 2
way closed.
(4) Adjust the upper run channel for proper align-
ment with the glass and tighten the two top screws.
(5)
Tighten the lower nut on the bottom of the low-
er run channels.
(6)
Run the glass up to approximately
9 6
inch be-
low the glass
run.
(7)
Adjust the regulator
so
the top of the glass is
parallel to the glass run. To raise or lower the left or
right side of the glass, raise or lower the regulator on
that side.
Glass Replacement
Removal fAP ModelsJ
(1) With
the tail gate open, remove the trim panel.
(2)
Remove the retainers (Fig. 131) from the ends
(3) Remove the regulator arm studs from the roll-
(4) Remove the tail gate glass assembly from the
(5)
Remove the rollers from the glass lower frame.
(6)
Remove the washers, spacers and screws attach-
ing the glass lower frame and weatherstrip to the glass
(Fig. 132) and remove the frame and weatherstrip.
Installation
(1) Position the outer belt weatherstrip on the low-
er glass frame.
(2)
Position the tail gate glass on the weatherstrip
and lower frame, and install the washers, spacers and
retaining screws.
(3) Apply lubricant to the regulator arm studs and
to the glass lower frame studs.
(4) Position the rollers into the slots of the glass
lower frame.
(5)
With the tail gate in the vertical position, in-
sert the glass assembly into the tail gate.
(6)
Position the regulator arm studs in the rollers
and install the retainers on the ends of the studs.
(7)
Adjust the tail gate glass and install the trim
panel.
Removal fAR-AV Models)
of the regulator arm studs.
ers in the glass lower frame.
tailgate.
(1) Lower the tail gate glass and open the tail gate.
(2)
Remove the attaching screws and remove the
(3) Remove the inside trim panel.
(4) With an assistant holding the instrument panel
switch in the "Up" position, operate the control switch
on the left side of the tail gate and support the glass
as
it emerges.
garnish moulding and handle.
TAL WASHER
'
NK942
Fig. 132-Tail
Gate Glass Attachment IAP Models1
(5)
Remove the regulator
arms
from the window
(6)
Remove the glass lower channel and bracket
frame and remove the glass from the tailgate.
(Figs. 133 and 134).
LOWER CHANNEL
AND BRACKET
WEATHERSTRIP
Fig. 133-Tail
Gate Glass Replacwnent (AR Models1
GLASS
RUBBER WASHER
METAL WASHER
6 4 x 3 8 5
Fig. 1 3 L T a i l Gate Glass Replacement IAV Models1
Hide quick links:
Advertisement
