Advertisement
TRANSMISSION-TORQUEFLITE
21 -1 07
universal joint sliding yoke splines as outlined in
Group "0."
Carefully guide the sliding yoke into the extension
housing and on the output shaft splines. Then con-
nect the propeller shaft to the rear axle pinion shaft
yoke.
On the 121Y2 inch wheelbase Plymouth Station
Wagon; refer to Group
2
and reinstall the torsion
bar rear anchor crossmember and rubber isolators as
outlined in "Torsion Bar Rubber Isolator."
(14) Install the speedometer drive pinion and
sleeve.
(15)
Connect the oil cooler lines to the transmission
and install the oil filler tube.
(16) Connect the throttle rod to the transmission
throttle lever.
Place the selector lever in the PARK position. In-
sert the control cable in the transmission case, push
inward on the cable making sure the lock spring en-
gages the cable. Install the control cable adjusting
wheel lock screw.
(17) Connect the wire to the neutral starting switch.
(18) Install the cover plate in front of the convert-
(19) Install the transmission case to cylinder block
NOTE: The converter cover plate must be between
the case and the brace. The oil line bracket is at-
tached in front of the brace. Tighten the bolts hold-
ing the brace to the case before attaching brace to
the cylinder block.
(20)
Refill the transmission with Automatic Trans-
mission Fluid Type "A" Suffix "A." Refer to Page 49.
for complete transmission filling instructions.
NOTE: To completely adjust the throttle linkage,
gearshift control cable, and neutral starting switch,
refer to Page
57, 58 and 59.
er assembly.
brace.
Hide quick links:
Advertisement
