Plymouth Valiant V-100 1965 Service – Technical Manual page 602

23-32 GLASS
PART 5
GLASS
FRONT DOOR
(Sedan Models)
Adjustments
IAP
Models]
Refer to Figure
63
for the adjustment points and
methods of adjustment for the door glass and vent
wing assembly.
(1) Open the door and run
the window approxi-
mately halfway down.
(2)
Adjust the glass run retainer screw at the bot-
tom
so
the glass moves in the run freely.
(3)
Run the window down
so
the top of the glass is
even with or slightly below the belt line of the door
outer panel.
(4)
On manually operated windows, position the
stop on the regulator plate against the stop on the
regulator sector.
STOPS
I , ?
K I N AND OUT
IN AND OUT NK873
Fig. 63-Front Door Glass Adjustments
IAP Modelsl ISedanl
TO RAISE FRONT OF WIND
ASSEMBLY RAISE MOUNTING P
TO LOWER FRONT OF WINDOW
ASSEMBLY LOWER MOUNTING
PLATE.
62x651 A
Fig. -Front Door Glass Adjustments
IAR Modelsl (Sedan)
(5) On electrically operated windows, reach through
the major access hole and position the down stop
against the bumper.
(6) Operate the window and inspect alignment and
test for ease of operation.
IAR Models]
Refer to Figure
64
for the adjustment points and
methods of adjustment for the door glass and vent
wing assembly. The adjustment procedures for the
front door glass are the same as those for the AP
Models.
IAV Models]
Vent Wing Adjustments (Fig.
65)
Fore-or-aft adjustment of the upper end
of
the vent
wing assembly is accomplished by moving the
vent wing and division channel up
or
down. The vent
wing assembly moves forward and downward to re-
lieve a door glass that is tight. It moves rearward and
upward to remove looseness.
The three vent wing attaching screws in the front
face of the door and the adjusting screws at the lower
end of the division channel must be loosened. Then,
with the glass raised, move the entire vent wing
as-
sembly up or down until the glass is free in the
channels
but
not
loose. Tighten the vent attaching
screws.
The lower vent wing pivot (Fig.
66)
on all AV mod-
els, is provided with a bracket-type pivot tension ad-
justment. The star wheel adjusting screw ratchet is
used to reduce or increase effort required to close and
VENT AllACHING
Fig. 65-Vent Wing Adjustments IAV
Modelsl