Advertisement
GLASS
23-57
(2) With the front door closed,
run
the window ap-
proximately three-fourths the way up.
(3) Adjust the upper stabilizer so the rear of the
window touches lightly on the cat whiskers.
(4)
Run the window up fully
so
the front of the
quarter window is flush with the top of the front door
window and the lower frame is parallel to the belt
line of the quarter outside panel.
(5) Adjust the upper track attachment so the front
of the window
is aligned with the rear of the door
window at the belt line. To move the window in, turn
the sleeve nut clockwise, and to move the window
out, turn the sleeve nut counterclockwise.
(6)
Adjust the lower track attachment so the front
window is aligned with the rear of the front door
window at the top. To move window in, turn the
sleeve nut counterclockwise and to move the window
out, turn the sleeve nut clockwise.
(7)
Adjust the pivot bracket
so
the window is par-
allel to the rear of the front door window
at
the
front and the bottom is parallel to the quarter out-
side panel at the belt line. Lower the pivot bracket
to raise the glass, and raise the bracket to lower the
glass.
(8)
Move the upper track attachment forward so
the weatherstrip is against the front door window.
(9) Position the up stop down against the rear
arm of the regulator.
(10) Run the window down so the top of glass is
level with or slightly below the belt line of the quar-
ter outside panel.
(11) Adjust the lower stabilizer attachment in or
out as necessary.
(12) On manually operated windows, position the
stop on the regulator plate against the stop on the
regulator sector. On electrically operated windows,
adjust the down stop against the bumper.
(13) Adjust the center support inboard against the
inside panel.
(14) Operate the window and test for ease of opera-
tion and alignment.
(15) Install the water shield, trim panel and regula-
tor handle.
Glass
Replacement (Convertible)
Removal (AP and
AR
Models)
(1) Remove the regulator handle, trim panel and
watershield and lower the quarter window assem-
bly.
(2) Remove the spring nuts from the regulator arm
studs (Fig. 125) and remove the studs from the rollers.
(3) Remove the rollers from the glass lower frame
slots.
(4) Raise the glass and lower the frame assembly
out of the quarter panel.
(5) Inspect the regulator arm stud rollers, and the
glass track rollers for damage or excessive wear.
Fig. 1 2 5 4 u a r t e r Window Replacement-
Convertible IAP ModelsJ
Installation
(1) Lubricate the glass lower frame regulator arm
roller slots and the track roller slot.
(2) Install the track roller assembly into the track
slot of the lower frame with the spring loop up.
(3) Position the glass assembly into the quarter
panel and install the regulator arm stud rollers into
the glass lower frame slots.
(4)
Raise the glass and lower the frame assembly
out of the quarter panel.
Fig. 1 2 M u a r t e r Window Replacement-
Convertible (AR ModelsJ
Hide quick links:
Advertisement
