Plymouth Valiant V-100 1965 Service – Technical Manual page 509

TRANSMISSION-TORQUEFLITE 21 -51
and clamp.
CAUTION: On the AP-1 and AP-2 models, be sure
to disconnect the gearshift indicator link before re-
moving the steering column to instrument panel
clamp.
(9)
AR-1, AR-2, AV-1 and AV-2 Models:
Remove the
steering column to instrument panel retaining clamp
and screws.
AP-1 and AP-2 Models:
Remove the screw that at-
taches the gearshift indicator link (slotted end) to the
operating lever on the column. Remove the steer-
ing column to instrument panel retaining clamp and
screws.
(10) On some models, disconnect the brake pedal
from the master cylinder so the pedal can be raised
to provide steering column removal clearance. Lift
the steering column up and off the end of the worm
shaft.
Fig. 5-Removing or Installing Steering Shaft
Snap Ring
Fig. &Back-up Lamp Switch and Operating
Lever IAR-7, AR-2, AV-1
,
AV-2 Models1
OPERATING
LEVER
K-UP LAMP SWITCH
\
/
Fig. 7-Back-up Lamp Switch and Operating
Lever ( A P - I , AP-2 Models1
PIVOT
SCREWS(3)
GEARSHIFT CABLE
\
PARKING
LOCK CABLE
wrq
-
NUT AND
WASHERS
LOCK
PLATES
SEAL (BOOT)
Fig. 8-Removing or Installing Steering
Column Lower Plate
NK303
Fig. 9-Removing or Installing Cable Hair Pin Locks