Advertisement
(6) Position the lift bracket and gasket on the glass
(7)
Adjust the glass and test for ease of opera-
(8) Install the water shield,
trim
panel, regulator
and install the plastic rivet.
tion.
handle, rear seat back and cushion.
Removal fAR Models)
Refer to Figure 78 and proceed as follows:
(1)
Remove the rear seat cushion and seat back.
(2) Remove the quarter glass handle, escutcheon,
(3) Remove the two retaining clips from the studs
(4)
Disengage the quarter glass from the lower
(5) Remove the glass up through the quarter panel.
arm rest, trim panel and water shield.
of the lower frame and roller assembly.
frame.
Ins tallat ion
ter panel.
stall new retaining clips.
spect for alignment of track and ease of operation.
(1)
Insert the quarter glass down through the quar-
(2) Engage the glass onto the lower frame and in-
(3) Lubricate the rollers and run tracks and in-
(4)
Adjust the quarter glass as necessary.
(5) Install the water shield, trim panel, escutcheon,
(6) Install the rear seat back and rear seat cushion.
handle and arm rest.
Removal fAV Models)
(1)
Remove the quarter trim panel and hardware.
(2) Lower the glass and reaching through the front
access opening, remove the clip from the regulator
arm stud pin.
(3)
Pull the regulator arm stud out of the plastic
bushing.
(4)
Push up on the front of the glass while holding
b
GLASS
/
LIFT
CLIP
64
x
380
Fig. 8 3 4 u a r t e r
Glass
Installation IAV Models)
the arm stud pin, until the front of the glass is clear
of the arm stu,d.
(5) Raise and rotate the front of the glass until the
lift arm bracket clears the regulator arm stud.
(6) Pull the glass up and out.
lnstallation
bracket (Fig. 82) and attach it to the new glass.
stud is accessible at the front access opening.
first into the quarter panel opening (Fig. 83).
the lift bracket onto the regulator rear arm stud.
the glass forward into the front channel.
(1) If the glass is to be replaced, remove the lift
(2) Roll the regulator down until the front regulator
(3) Lower the quarter glass and bracket, rear edge
(4)
Reach through the access opening and position
(5) Rotate the glass into rear channel and move
LIFT B R A C K E T - , , ,
RIVET
( Q .
64x381
Fig. 82-Quarter
Glass Attachment IAV Models)
LUBRICANT-:
/
L . ,
NK1156
Fig. 84-Regulator
Assembly IAP Models)
Hide quick links:
Advertisement
