Advertisement
GLASS
23-41
1
IVOT RRACKET
REGU
Fig. 88-Rear
Door
Glass Adjustments-
Sedan IAP Models)
(3) Install the run retainer screw at the window
(4)
Tighten the retainer support bracket screw se-
(5)
Position the glass run into the quarter panel.
(6)
Index the run into the upper front corner of
the window opening frame.
(7)
Press the run into the channel between the in-
ner and outer panels and into the rear lower run re-
tainer.
( 8 )
Install the quarter window and test the opera-
tion of the glass.
frame and drain trough area.
curely.
REAR DOORS (Sedan Models)
Adjustments fAP Models)
below the door frame.
(1)
Run the window up to approximately
'/s
inch
(2)
Adjust the regulator pivot bracket (Fig. 88) so
TO RAISE FRONT
O F
WINDOW ASSEMBLY
LOWER FRONT OF
PIVOT RRACKET.
TO LOWER FRONT
OF WINDOW ASSEMBLY
RAISE FRONT OF
RACKET.
DOWN STOP
ELECTRIC WINDOW
62x645~
Fig. 89-Rear
Door Glass Adjustments-
Sedan IAR Models)
IN AND OUT
ADJUSTMENT
-
IN
AND OUT
ADJUSTMENT
FORE AND AFl
ADJUSTMENT
L - - , - - '
'
D O W N STOP
63x98
Fig. 90-Rear
Door Glass Adjustments-
Sedan IAV Models)
the gap between the top of the glass and door frame
is the same along the entire length. To raise the front
of the glass, lower the front of the pivot bracket and
to lower the front of the glass, raise the front of the
pivot bracket.
(3) On manual operated regulators, run the window
down
so
the top of glass is even with or slightly be-
low the belt line.
(4)
Position the stop on the regulator plate against
the stop on the regulator sector and tighten the nut.
(5) Operate the window and inspect alignment and
for ease of operation.
(AR Models)
methods of adjustment of the door glass.
Refer to Figure 89 for the adjustment points and
(AV
Models)
The front glass run is fixed except for in-or-out ad-
justment at its lower end. The division channel can
be adjusted fore or aft, as well as in or out (Fig. 90).
If adjustment of the division channel is necessary
to relieve a bind when the glass is raised, loosen the
upper channel attaching screw. Generally, sufficient
movement of the channel is possible at this point to
correct any binding or looseness of the glass. How-
ever,
if
additional channel movement is required, this
can be obtained by lowering the glass and loosening
the two attachment screws at the lower end of the
channel.
Alignment of the front glass channel with the divi-
sion channel can be accomplished by adjusting the in-
or-out adjusting screw, accessible on the front face of
the door. If additional in-or-out movement is required
to obtain proper alignment of the glass, adjust the
in-or-out adjusting screw at the lower end of the di-
vision channel.
Hide quick links:
Advertisement
