Advertisement
INSTRUMENTS
8-75
TURN SIGNAL SYSTEM
SERVICE PROCEDURES
Removed
(1) Disconnect the battery ground cable.
(2) For Models AR-1, AR-2, AP-1 and AP-2, com-
press and turn the horn button
y4
turn counter-clock-
wise to release the button from the retainer. On mod-
els equipped with a horn blowing ring remove the 2
attaching screws from the underside of the steering
wheel. For Models AV-1 and AV-2 pry the cap off of
the horn button with a screwdriver using care to
avoid damage to the cap.
(3) Disconnect the horn wire at the horn blowing
switch.
(4)
Remove the three (3) Screws and insulators at-
taching the horn ring and horn blowing switch to the
steering column. Remove the horn ring and switch.
(5)
Loosen the steering wheel nut several turns
and install the Steering Wheel Puller Tool C-3428 and
remove the steering wheel nut and steering wheel.
(6)
Remove the screw attaching the turn signal op-
erating lever to the turn signal switch and remove
the lever.
(7)
Disconnect the switch wiring at the steering
column jacket tube below the instrument panel.
NOTE:
Attach a piece of string or fine wire to the
switch wiring before removing the switch from the
steering column. When the switch is removed leave
the string or wire in the steering column jacket
tube as an aid to replacement of the wiring.
(8)
Remove the screws attaching the turn signal
switch to the steering column and remove the switch
from the top of the steering column.
Installation
(1) Attach the string or
wire, (that was left in the
steering column jacket tube during removal), to the
turn signal switch wiring and carefully pull the string
or wire down through the column jacket tube until
the turn signal switch is positioned in the steering
column jacket tube. Install the attaching screws and
connect all wire connections.
(2) Install the turn signal switch lever.
(3)
Install the steering wheel and the steering
wheel nut. Tighten to 24 foot-pounds. Test the opera-
tion of the cancelling lever.
(4)
Install the horn blowing switch, horn ring, in-
sulators and attaching screws. Connect the horn wire
at the horn blowing switch.
( 5 )
For Models AR-1, AR-2, AP-1 and AP-2 install
the horn button
by
compressing and turning
4/4
turn
clockwise to lock the horn button on the retainer. On
models equipped with a horn blowing ring install the
2 attaching screws from the underside of the steering
wheel. For Models AV-1 and AV-2 press the cap onto
the horn blowing button.
(6)
Connect the battery ground cable.
Hide quick links:
Advertisement
