Plymouth Valiant V-100 1965 Service – Technical Manual page 15

0-8 LUBRICATION
Fig. 1 1-Column-Mounted Manual Transmission
Gearshift Control-Lubrication Points
Fig. 13-Floor-Mounted Manual Transmission
Gearshift Mechanism-Lubrication Points
To gain access to these areas, remove the clutch in-
spection plate at bottom of clutch housing and the
fork boot and fork.
CAUTION: Care must be taken to avoid getting
lubricant on clutch disc and pressure plate.
Column-Mounted Manual Transmission
Gearshift Controls
Apply a film of Multi-Mileage Lubricant, Part No.
2525035 or Automotive Multi-Purpose Grease, NLGI
Grade 2, to contact surfaces (Fig. 11).
Column-Mounted Automatic Transmission
Controls
The control mechanism is located at the lower end
of the steering column in the engine compartment. It
is sealed inside a rubber boot which should be in-
NK560
spected for condition and position.
If the boot is damaged, it should be replaced and
the mechanism lubricated by applying a film of Multi-
Mileage Lubricant, Part Number 2525035, or Automo-
tive Multi-Purpose Grease, NLGI Grade 2 (Fig. 1 2 ) .
Floor-M ounted Manual Transmission
Gearshift Mechanism
Lubricate the mechanism from under the vehicle
(Fig. 13), using SAE 30 engine oil applied with a pump
type oil can.
Make sure the stone shield for the lower
shift housing is in place.
Floor-Mounted Automatic Transmission Controls
Lubricate the controls (Fig. 14) using SAE 30 en-
gine oil applied to the connections with a pump
type oil can. Access to the controls is by removing
the console top trim panel.
NK562
\ &
Fig. 12-Column-Mounted Automatic Transmission
Fig. 1 &Floor-Mounted Automatic Transmission
Controls-Lubrication Points Controls-Lubrication Points