Advertisement
GLASS
23-37
(7) Slide the regulator arm link out of the pivot
channel and remove the regulator from the door.
Installation
(1) Lubricate the channel of the regulator arm piv-
ot and the slides of the glass lower channel with
lubriplate.
(2) Insert the regulator and link into the door and
engage the pivot arm into the run of the pivot channel
(Fig. 76).
(3) Install the link and mounting plate screws finger
tight.
(4)
Install the regulator screws and progressively
tighten to 60 inch-pounds torque.
(5) Lower the door glass and engage the regulator
arm studs into the slides of the glass lower channel.
(6) Install the retaining clips on the studs of the
regulator arm studs (Fig. 7 3 ) .
(7) Test the operation of the regulator.
(8) Adjust the level of the glass.
(9) Install the water shield, trim panel, door handles,
arm rest and remote lock knob.
Regulator Replacement
Removal fAV Models)
(1)
Remove the door interior trim and hardware.
(2)
Loosen the front run channel lower mounting
(3) Move the run channel forward and slide the glass
(4) Remove the regulator arm from the lift brack-
(5)
Remove the glass from the door by lifting
(6)
Remove the regulator attaching screws and the
screw.
out of the channels.
et channel.
straight up.
regulator.
Installation
stall the mounting screws.
slide.
(1)
Position the regulator on the door panel and in-
(2) Lubricate the lower glass channel regulator
(3) Position the glass into the door frame.
(4)
Position the regulator arm roller into the lift
(5) Position the glass into the glass run channels
(6) Install the door interior trim and hardware.
bracket channel.
and adjust the door glass.
QUARTER WINDOWS (Sedan Models)
Adjustments (AP Models)
Refer to Figure 77 for sedan quarter glass adjust-
ing points.
(1)
Run the glass up to approximately % inch be-
low the window opening frame.
(2)
Adjust the regulator pivot bracket so the gap at
the top of the window is parallel to the window open-
REGU
ST
Fig. 7 7 4 u a r t e r Glass Adjusting Points-
Sedan IA P Modelsl
ing frame. To lower the front of glass, raise the front
of the pivot and to raise the front of glass lower the
front of the pivot.
(3) Loosen the rear run retainer screw and lower
the window halfway to allow the rear run to align
it-
self with the glass.
(4)
Tighten the rear run retainer screw.
(5) Lower the glass
so the top is even with or slight-
ly below the belt line of the outside panel.
(6) Position and tighten the stop on the regulator
plate against the stop on the regulator sector.
(7) Position the rear run retainer forward against
the rear edge of the glass. Tighten the screw secure-
(8)
Operate window and inspect appearance, align-
l Y
*
ment and operating qualities.
fAR Models)
Refer to Figure 78 for the adjustment points and
TO RAISE FRONT OF WINDOW
ASSEMBLY RAISE REGULATOR
TO LOWER FRONT OF
WINDOW ASSEMBLY
L
ASSEMBLY.
I
LOWER REGULATO
ASSEMBLY.
IN AND OUT
FORE AND AFT
AND OUT
AND AFT
,/
i
.\
62X646A
Fig. 7 8 4 u a r t e r Glass Adjusting Points-
Sedan fAR Modelsl
Hide quick links:
Advertisement
