Advertisement
23-82
CONVERTIBLE MAINTENANCE
22%
DRAIN POCKET FLAP
RETA~NER
I
SOCKET
CAP
/r
NK920
3 L K C W
Fig. 7 8 7 4 u a r t e r Panel Well Flap Retainers
wire of the test lamp to the black wire terminal on
the pump motor and ground the other wire of the
test lamp. Move the top control lever to the right.
The test lamp should light. If the test lamp does not
light, the black wire between the pump motor and the
control switch is faulty and should be replaced. Re-
peat this test at the green wire terminal, moving the
top control lever to the left. If the test lamp lights in
both cases but the pump motor fails to operate, re-
pair or replace the pump motor as necessary.
FOLDING TOP WELL LINER (FIG. 180)
Removal
(1) Place a protective cover on the deck lid upper
panel and quarter panel areas.
(2) Place masking tape below the lower edges of
the rear window and quarter panel belt mouldings and
remove the mouldings.
(3) Remove the well flap retainers from the inner
quarter panel (Fig. 181) and disconnect the rear bow
tension cable (Fig. 177) at the lower bracket.
(4)
Mark the location of the moulding retainer
screw holes on the masking tape and remove the re-
tainers.
(5)
Mark the position of the curtain and top cover
screw holes on the masking tape and remove the
screws.
(6)
Remove the well liner, seals and sealers.
(7) Clean the sealing and cementing areas thor-
oughly to assure good adhesion on the new liner.
lnstallation
(1) Install a strip of sealer cement, 120 inches long,
to the top of the quarter outside panels and deck
opening upper panel (at the belt area).
(2)
Apply an even coat of cement over the sealer
cement and the adjacent metal surfaces. The width of
the cement should not exceed the width of the well
liner.
FRONT RAIL
WEATHERSTRIP
CEMENT
HEADER
'RIP
\ \ ',,\\\
,RETAINER-FRONT
& - C E M E N T
I
b
RETAINELREAR
NK922
Fig. 7 82-Roof
Side Rail Weatherstrip
IAP Models)
(3) Apply an even coat of cement to the rear seat
back support and the well liner attaching surfaces on
the wheelhousings.
(4)
Apply a double adhesive sided foam pad to the
wheelhouse caps at the rear seat back supports.
(5)
Install the drain tube connector and retainer to
the new liner.
(6)
Install an even coat of cement
to
the bottom
edge of the liner attaching edges.
(7) Position the new well liner in the well and press
the attaching surfaces to the cemented surfaces.
(8) Slit the liner (2 places) on the rear seat back
support for the tension cables and attach the tension
cables.
(9)
Apply polyethylene seals
60
inches long to the
belt areas on the quarter outside panels and to the
deck upper panel over the installed well liner.
(10)
Pierce the seals and liner cover at the retainer
screw holes, using the reference marks on the mask-
ing tape.
RETAINER
NK970
Fig. 7 83-Top
Header Front Weatherstrip
IAP Models)
Hide quick links:
Advertisement
