Advertisement
23-2
BODY AND SHEET METAL-DIAGNOSIS
OUTSIDE HANDLE
DOES
NOT
RELEASE
LOCK
(a) Lock adjustment set too
high.
(b) Outside handle to lock link disconnected.
(c) Ineffective release lever spring or damaged
transmitter or detent actuator.
INSIDE RELEASE ROD
DOES NOT RELEASE
LOCK
(a) Remote control assembly improperly adiusted.
DOOR LOCK DOES
NOT HOLD DOOR
CLOSED (False Latching)
(a) Rotor pawl or lever may be jammed or bent.
ENTIRE
DOOR
RATTLES OR MOVES
EXCESSIVELY WHEN
DRIVING
(c) Loose rotor.
(a) Door rubber bumpers missing on back
o f
door
(b) Improperly adjusted lock striker.
flanges or pillars.
(d) Welds broken and rotor cover loose.
CONVERTIBLE TOP
FOLDING
TOP
HEADER
AND WINDSHIELD
HEADER NOT
MEETING
AT CORRECT ANGLE
(a) Incorrect front and rear side rail adjustment.
"JACK
KNIFING" OF
THE SIDE RAILS AT THE
Models)
(a) Improper alignment
o f
side rails to top of
window glass.
RAIL HINGES (AV-AR
IMPROPER MEETING
(fore and aft)
OF
FOLD-
ING
TOP HEADER WITH
WINDSHIELD HEADER
(a) Improper adjustment of power link.
FOLDING
TOP
HEADER
NOT IN
ALIGNMENT
WITH GUIDE DOWELS
ON
WINDSHIELD
HEADER
(a) Improper adjustment of folding top header.
TOP FABRIC TOO
LOOSE
OR TOO TIGHT
(a) Improper adjustment of number
I
roof bow.
AIR OR WATER LEAKS
AT WINDSHIELD HEADER
adjusted.
(a) Folding top header torsion bar not properly
(a) Adjust lock.
(b) Be sure flattened end of link i s not too wide
spreading the clip. File the edge flat so clip
fits freely. Install link.
(c) Install new lock.
(a) Adjust control mechanism until it will com-
pletely lock and release lock.
(a) Install new lock.
(a) Install bumpers where required.
(b) Adjust striker.
(c) Re-rivet inside and outside rotors. Install a new
lock if damaged.
(d) Install new lock.
(a) With top in the "up" position and header lock
in, turn screw at front side rail hinge and set
screw at rear side rail hinge (AV-AR Models)
until they contact header.
(a) Adjust by moving serrated adiustment plate up
or down to hold side rails in their correct re-
lationship to window frame. Adjust both sides
to same height to maintain parallelism of side
rails.
(a) Adjust power link "fore and aft" across ser-
rated plate. Adjustment is in direction of move-
ment desired.
(a) Adjust folding top header "fore and aft" until
alignment with guide dowels i s accomplished.
(a) Adjust roof bow up or down on bow support
(AV-AR Models).
(a) Adjust folding top header torsion bar to ac-
complish a
30
pound locking handle effort.
Hide quick links:
Advertisement
