Plymouth Valiant V-100 1965 Service – Technical Manual page 606

23-36 GLASS
(6) Locate the run channel anchor and adjusting
screw into the door bracket and tighten the lock nut.
(7) Adjust the door glass.
(8)
Install the water shield, trim panel, inside han-
dles, arm
rest
and remote lock button.
Door Glass
Removal
fAV Models)
(1) Remove the door interior trim and hardware.
(2) Loosen the front run channel lower mounting
(3) Move the run channel forward and slide the
(4)
Remove the regulator arm from the lift brack-
(5) Remove the glass from the door by lifting
screw.
glass out of the channels.
et channel.
straight up.
Glass Lift
Bracket
To separate the lift bracket (Fig.
74)
from the
glass, just push the plug out of the rivet (Fig. 7 5 ) .
Next, pinch the expandable ends of the rivet together
and push the rivet out of the glass. Save the plastic
rivet and plug. The plug and rivet are reusable.
To assemble the bracket to the glass, line up the
holes in the glass, gasket and lift bracket. Push the
plastic rivet through from the lift bracket side.
Just make sure that the head of the plastic rivet is
tight against the bracket and the expandable end of
the rivet is all the way through the hole in the glass.
Drive the plug into the rivet to lock the rivet in
place.
lnstallation
slide of the lower glass channel.
Before installing the glass, lubricate the regulator
(1) Position the glass into the door frame.
I /
I
GLASS
I
LIFT BRACKET ASSEMBLY
Fig. 7 6 G l a s s Lift Bracket IAV Models)
64
x
374
Fig. 75-Removing the Lift Bracket
(2)
Position the regulator arm roller into the lift
(3) Position the glass into the glass run channels
(4)
Install the door interior trim and hardware.
bracket channel.
and adjust the door glass.
Regulator Replacement
Removal fAR Models)
mote lock knob, trim panel and water shield.
clips from the regulator arm studs (Fig. 73).
of the glass lower channel.
(1)
Remove the inside door handles, arm rest, re-
(2) Lower the door glass and remove the retaining
(3) Remove the regulator arm studs from the
runs
(4)
Prop the glass in the up position.
(5) Remove the window regulator attaching screws
(6)
Remove the link and mounting plate attaching
(Fig.
76).
screws.
64 x 434
Fig. 76-Front Door Window Regulator
IAR Models)