Plymouth Valiant V-100 1965 Service – Technical Manual page 287

9-30 ENGINES--&CYLINDER
ROCKER SHAFT
L
K E R SHAFT STRU
Fig. 6 3 4 n s t a l l i n g Rocker Arms
1318 Cubic lnchl
sembly
.
Remove the lock plug, slide the rocker shaft out of
the rocker shaft struts disengaging the rocker arms
and springs (Fig.
62).
Installation
Slide the rocker shaft into bore of strut and at
the same time engage intake rocker arm (Fig. 63). In-
stall spring and engage exhaust rocker arm. Install
remainder of the rocker arms in same sequence.
Make sure that head bolt holes in rocker shaft line up
with head bolt holes in rocker shaft strut. In addition,
the plug hole in strut must also line up with hole in
rocker shaft. Tap in rocker arm shaft plug (Fig. 64).
Install plugs in both ends of rocker arm shaft.
INTAKE ROCKER ARM
EXHAUST
ROCKER ARM
R O C K E R SHAFT L O C K PLUG,
\
?J!&
0
ADJUSTING SCREW
INTAKt
PASSACjtS
EXHAUST CROSSOVER PASSAGE
\
63x 711 INTAKE P~SSAGES
Fig. 64-Cylinder Head Assembly
131 8 Cubic Inch)
Fig. 65-Rocker Arm Assemblies Installed
Removal
1273, 361, 383 8 426 Cubic
Inch
Engines)
(1)
Remove the cylinder head cover and gasket.
(2) Remove the bolts that attach the rocker arm
shaft to the cylinder head and remove the rocker
arms and shaft as an assembly.
(3) If the rocker arm assemblies have been disas-
sembled for cleaning, inspection, or replacement, re-
fer to Figure
65
for proper reassembly.
Installation
(1) On 273 Cubic Inch Engine only, install the rock-
er arm and shaft assemblies with the "NOTCH" on the
end of the rocker shaft pointing to the centerline of /p
ROCKER SliAFr B O L T - - ,
RIGHT BANK LEFT BANK
62 X 23
Fig. 66-Rocker Arm lubrication Holes
1361,383
6
426 Cubic lnchl