Suzuki XL7 2007 Service Manual page 788

1F-45 Engine Cooling System:
6. Remove the water pump bolts.
7. Remove the water pump.
8. Remove and DISCARD the water pump seal.
9. Carefully clean the water pump sealing surfaces.
Installation Procedure
1. Install a NEW water pump seal.
2. Install the water pump.
CAUTION
!
Refer to "Fastener Notice: ".
3. Install the water pump bolts.
Tightening torque
Tighten the water pump bolts to 10 N⋅m (89 lb in).
4. Install the water pump pulley and the water pump
pulley bolts.
5. Use the EN 46104 in order to retain the water pump
pulley.
6. Install the water pump pulley bolts.
Tightening torque
Tighten the water pump pulley bolts to 10 N⋅m
(89 lb in).
7. Install the drive belt. Refer to "Drive Belt
Replacement: ".
8. Fill the cooling system. Refer to "Draining and Filling
Cooling System (LY7 GE 47716 Fill)" "Draining and
Filling Cooling System (LY7 Static Fill)".