Installation Procedure
1. Install the reservoir seals to the master cylinder
body.
2. Install the reservoir to the master cylinder body by
pushing the reservoir bayonets straight down into the
seals in the master cylinder body.
3. Install NEW reservoir attachment pins. Ensure that
the attachment pins are fully and firmly seated.
4. Install the brake fluid level sensor. Refer to "Master
Cylinder Fluid Level Sensor Replacement".
Brake Control System and Diagnosis:
5. Connect the brake fluid level sensor electrical
connector.
6. Install the underhood electrical center. Refer to
"Underhood Electrical Center or Junction Block
Replacement: ".
7. Fill the master cylinder reservoir. Refer to "Master
Cylinder Reservoir Filling".
8. Bleed the brake system. Refer to "Hydraulic Brake
System Bleeding (Pressure)" "Hydraulic Brake
System Bleeding (Manual)".
Master Cylinder Replacement
Removal Procedure
WARNING
!
Refer to "Brake Fluid Irritant Caution: ".
CAUTION
!
Refer to "Brake Fluid Effects on Paint and
Electrical Components Notice: ".
4A-46