Suzuki XL7 2007 Service Manual page 855

7. Connect the chassis fuel feed line quick connect
fitting to the fuel tank. Refer to "Plastic Collar Quick
Connect Fitting Service".
8. Connect the EVAP canister fresh air hose/pipe to the
fuel tank fresh air hose/pipe (2). Refer to "Plastic
Collar Quick Connect Fitting Service".
9. Connect the EVAP canister vent hose/pipe to the
EVAP canister (1). Refer to "Plastic Collar Quick
Connect Fitting Service".
10. Install the propeller shaft. Refer to "Propeller Shaft
Replacement: "Propeller Shaft Replacement.
11. Install the muffler assembly. Refer to "Muffler
Replacement: ".
12. Lower the vehicle.
13. Fill the fuel tank with gasoline.
14. Connect the negative battery cable. Refer to "Battery
Negative Cable Disconnection and Connection: ".
15. Tighten the fuel fill cap.
16. Prime the fuel system:
a. Cycle the ignition ON for 5 seconds and then
OFF for 10 seconds.
b. Repeat the previous step twice.
c. Crank the engine until it starts. The maximum
starter motor cranking time is 20 seconds.
d. If the engine does not start, repeat steps 16.1-
16.3.
17. Install the fuel injector sight shield. Refer to "Fuel
Injector Sight Shield Replacement: ".
Fuel Tank Pressure Sensor Replacement
Removal Procedure
1. Remove the fuel tank. Refer to "Fuel Tank
Replacement (FWD)" "Fuel Tank Replacement
(AWD)".
2. Disconnect the fuel pump module harness electrical
connector from the fuel tank pressure sensor.
3. Position 2 flat-bladed screwdrivers, one on each side
of the sensor, near the vacuum port.
4. Carefully use the screwdrivers to lift and release the
sensor from the fuel pump module.
Fuel System: 1G-55