Suzuki XL7 2007 Service Manual page 442

1D-102 Engine Mechanical:
10. Insert the EN-48313 between the camshaft
actuators, rearward of the timing chain until the
bottom line that is scribed in the body of the tool (2)
is adjacent to the top surface of the cylinder head
(1). This is the approximate installed position.
NOTE
The engine front cover is removed for clarity
in the following graphics, but NOT required
to perform the procedure.
11. Ensure that the feet (4) on the legs of the tool are
facing the front of the engine.
12. Partially expand the legs (1, 3) of the EN-48313 by
turning the T-shaped handle clockwise.
13. Insert the leg of the tool (1) behind the timing chain
guide (2).
14. Continue expanding the EN-48313 until the legs (1,
3) contact the timing chain. Do not tighten at this
time.
NOTE
Ensure that the foot (1) of the EN-48313 is
engaged into one of the link pockets to
prevent tool slippage during tightening of the
EN-48313.
15. Hand tighten the EN-48313.
CAUTION
!
Refer to "Torque Reaction Against Timing
Drive Chain Notice: ".
16. Use an open end wrench on the hex cast into the left
intake and exhaust camshafts and rotate the
camshafts toward each other in order to create slack
in the chain between the actuators.
17. The EN-48313 is now properly installed to hold the
timing chain in position.
CAUTION
!
Refer to "Torque Reaction Against Timing
Drive Chain Notice: ".