Table of Contents
Advertisement
1D-138 Engine Mechanical:
CAUTION
!
Do not pry between the engine front cover
and the camshaft position sensors or the
camshaft position actuators in order to shear
the RTV. Use the pry points and a bolt in the
jackscrew hole in order to remove the engine
front cover. Damage to the camshaft position
sensors or the camshaft position actuators
may occur if the camshaft position sensors
or the camshaft position actuators are used
to pry against in order to remove the engine
front cover.
8. Loosely install a 10 x 1.5 mm bolt in the jackscrew
hole (1).
9. Using the pry points (2) located at the edge of the
front cover and the jackscrew, shear the room
temperature vulcanizing (RTV) sealant.
10. Remove the engine front cover.
11. Using the EN 46111, rotate the crankshaft until the
left cylinder head camshafts align with the EN
46105-2 and the right cylinder head camshafts align
with the EN 46105-1.
12. Install the EN 46105-1 to the right camshafts.
Advertisement
Table of Contents
Troubleshooting
