Suzuki XL7 2007 Service Manual page 593

CAUTION
!
Refer to "Fastener Notice: ".
10. Tighten the inboard bolts (1-8).
Tightening torque
Tighten the inboard bolts to 20 N⋅m (15 lb ft) plus
80 degrees.
11. Tighten the outboard bolts (9-16).
Tightening torque
Tighten the outboard bolts to 15 N⋅m (11 lb ft)
plus 110 degrees.
12. Tighten the short/inner bolts (17-20).
Tightening torque
Tighten the short/inner bolts to 30 N⋅m (22 lb ft)
plus 60 degrees.
13. Tighten the long/outer bolts (21-24).
Tightening torque
Tighten the long/outer bolts to 30 N⋅m (22 lb ft)
plus 60 degrees.
NOTE
Do not rotate the crankshaft.
14. After reaching final torque, allow the assembly to sit
for 2 minutes.
15. Remove the crankshaft bearing cap side bolts.
Engine Mechanical: 1D-253