Suzuki XL7 2007 Service Manual page 454

1D-114 Engine Mechanical:
4. Install the EN 46110 above the applicable valve
spring as shown.
Tighten the EN 46110 valve spring compressor nut
(2).
5. Install the valve spring keepers.
6. Remove the EN 46110.
7. Disconnect the J 39313 from the compressed air
source.
8. Remove the J 39313.
9. Install the spark plugs. Refer to "Spark Plug
Replacement: ".
10. Install the rocker arms and camshafts. Refer to
"Camshaft Replacement - Left Side".
11. Remove the EN 46106 in order to prevent crankshaft
rotation.
12. Install the starter motor. Refer to "Starter Motor
Replacement: ".
Valve Stem Oil Seal and Valve Spring
Replacement - Right Side
Special tool
EN 46106 Flywheel Holding Tool
EN 46110 On-Vehicle Valve Spring Compressor
EN 46116 Valve Stem Seal Remover/Installer
J 39313 Spark Plug Port Adapter
Removal Procedure
1. Remove the starter motor. Refer to "Starter Motor
Replacement: ".
NOTE
If the EN 46106 is not installed, the crankshaft
may rotate. If the crankshaft rotates,
disassembly and reassembly of the entire
camshaft timing system may be required.
2. Install the EN 46106 in order to prevent crankshaft
rotation.
3. Remove the camshafts and rocker arms. Refer to
"Camshaft Replacement - Right Side".
4. Remove the spark plug from the applicable cylinder.
Refer to "Spark Plug Replacement: ".
5. Install the J 39313 to the applicable cylinder.
6. Connect the J 39313 to a compressed air source.