1D-156 Engine Mechanical:
Cylinder Head Removal - Left Side
Reference: "Valve Lifter Removal - Left Side: ".
1. Remove the two front M8 left cylinder head bolts.
2. Remove the left cylinder head bolts.
3. Remove the left cylinder head.
4. Remove and discard the left cylinder head gasket.
Reference: "Cylinder Head Disassemble: ".
Camshaft Removal - Right Side
Reference: "Camshaft Position Actuator Removal - Right
Side Intake (Third Design): ".
Reference: "Camshaft Position Actuator Removal - Right
Side Intake (Fourth Design): ".
Special tool
EN 46105 Camshaft Locking Tool
1. Remove the EN 46105-1 from the right camshafts.
2. Position the camshaft lobes in a neutral position.
3. Observe the markings on the bearing caps. Each
bearing cap is marked in order to identify its location.
The markings have the following meanings:
– The raised feature must always be oriented
toward the center of the cylinder head.
– The I indicates the intake camshaft.
– The E indicates the exhaust camshaft.
– The number indicates the journal position from the
front of the engine.