Table of Contents
Advertisement
2C-21 Rear Suspension:
6. Install the shock to the lower control arm nut and
bolt.
Tightening torque
Tighten the lower shock bolt and nut to 110 N⋅m
(81 lb ft).
7. Remove the jackstand from under the vehicle.
8. Install the stabilizer shaft link. Refer to "Stabilizer
Shaft Link Replacement".
9. Install the rear tire and wheel assembly. Refer to
"Tire and Wheel Removal and Installation: ".
10. Lower the vehicle.
Coil Spring Insulators Replacement
Removal Procedure
1. Remove the coil spring. Refer to "Coil Spring
Replacement".
2. Remove the upper and lower rubber insulators from
the coil spring.
Installation Procedure
NOTE
• Spray silicon lubricant on the insulators to
aid in installation.
• Make sure that part number identification
tape located on the coil spring is oriented
outboard of the vehicle and at the top of
the spring.
• Make sure to fully seat the top and bottom
coil spring insulators to the spring.
1. Install the upper and lower rubber insulators to the
coil spring.
2. Install the coil spring. Refer to "Coil Spring
Replacement".
Advertisement
Table of Contents
Troubleshooting
