Table of Contents
Advertisement
1D-140 Engine Mechanical:
6. Remove the engine front cover deadener.
7. Remove the remaining engine front cover bolts.
CAUTION
!
Do not pry between the engine front cover
and the camshaft position sensors or the
camshaft position actuators in order to shear
the RTV. Use the pry points and a bolt in the
jackscrew hole in order to remove the engine
front cover. Damage to the camshaft position
sensors or the camshaft position actuators
may occur if the camshaft position sensors
or the camshaft position actuators are used
to pry against in order to remove the engine
front cover.
8. Loosely install a 10 x 1.5 mm bolt in the jackscrew
hole (1).
9. Using the pry points (2) located at the edge of the
front cover and the jackscrew, shear the room
temperature vulcanizing (RTV) sealant.
10. Remove the engine front cover.
Advertisement
Table of Contents
Troubleshooting
