Table of Contents
Advertisement
Exhaust Manifold Heat Shield Replacement
- Right Side
Removal Procedure
WARNING
!
Refer to "Exhaust Service Caution".
WARNING
!
Refer to "Protective Goggles and Glove
Caution: ".
1. Remove the fuel injector sight shield, if necessary.
Refer to"Fuel Injector Sight Shield Replacement: ".
2. Disconnect the engine wiring harness electrical
connector (3) from the heated oxygen sensor
(HO2S) electrical connector (2).
3. Remove the HO2S electrical connector retainer from
the camshaft cover.
4. Remove the exhaust manifold heat shield bolts.
5. Remove the exhaust manifold heat shield, sliding the
shield up over the HO2S pigtail.
Installation Procedure
1. Install the exhaust manifold heat shield, sliding the
shield down over the HO2S pigtail.
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the exhaust manifold heat shield bolts.
Tightening torque
Tighten the bolts to 10 N⋅m (89 lb in).
3. Connect the engine wiring harness electrical
connector (3) to the HO2S electrical connector (2).
4. Install the HO2S electrical connector retainer to the
camshaft cover.
5. Install the fuel injector sight shield, if necessary.
Refer to "Fuel Injector Sight Shield Replacement: ".
Exhaust System:
1K-20
Advertisement
Table of Contents
Troubleshooting
