Suzuki XL7 2007 Service Manual page 335

Knock Sensor Replacement - Bank 1
Removal Procedure
1. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
2. Remove the rear exhaust manifold heat shield bolts
and shield.
3. Remove the right catalytic converter. Refer to
"Catalytic Converter Replacement - Right Side: ".
4. Disconnect the engine wiring harness electrical
connector (2) from the bank 1 knock sensor.
Engine Electrical Devices:
5. Loosen the knock sensor bolt and remove the knock
sensor.
Installation Procedure
CAUTION
!
Refer to "Fastener Notice: ".
1. Position the knock sensor and tighten the knock
sensor bolt.
Tightening torque
Tighten the bolt to 23 N⋅m (17 lb ft).
1C-29