Suzuki XL7 2007 Service Manual page 1263

Master Cylinder Fluid Level Sensor
Replacement
Removal Procedure
1. Remove the underhood electrical center. Refer to
"Underhood Electrical Center or Junction Block
Replacement: ".
2. Disconnect the brake fluid level sensor electrical
connector.
3. While simultaneously depressing the retaining tabs
on the opposite side of the sensor electrical
connection, carefully pull the sensor from the master
cylinder reservoir.
4. Remove the low brake fluid level sensor.
Brake Control System and Diagnosis:
Installation Procedure
1. While noting the proper orientation, install the brake
fluid level sensor to the master cylinder.
2. Press the brake fluid level sensor firmly into the
master cylinder reservoir, ensuring that the retaining
tabs are fully engaged.
3. Connect the brake fluid level sensor electrical
connector.
4. Install the underhood electrical center. Refer to
"Underhood Electrical Center or Junction Block
Replacement: ".
4A-44