Table of Contents
Advertisement
Stop Lamp Switch Replacement
Adjustment Procedure
1. Remove the left instrument panel (I/P) insulator
panel. Refer to "Instrument Panel Insulator Panel
Replacement - Left Side: ".
CAUTION
!
Proper stoplamp switch adjustment is
essential. Improper stoplamp switch
adjustment may cause brake drag, heat
buildup and excessive brake lining wear.
2. Disconnect the electrical connector from the stop
lamp switch.
3. Rotate the switch counterclockwise and remove the
switch from the switch retainer.
NOTE
Do NOT depress the brake pedal assembly
during the stop lamp switch installation. This
will cause a drag condition on the brake.
Brake Control System and Diagnosis:
4. Install the switch to the bracket by turning and
pushing the switch until the switch bottoms on the
brake pedal.
5. Connect the electrical connector to the stop lamp
switch.
6. Inspect the stop lamps for proper operation
7. Install the left I/P insulator panel. Refer to
"Instrument Panel Insulator Panel Replacement -
Left Side: ".
Front Brake Hose Replacement
WARNING
!
Refer to "Brake Fluid Irritant Caution: ".
CAUTION
!
Refer to "Brake Fluid Effects on Paint and
Electrical Components Notice: ".
Removal Procedure
1. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
2. Remove the tire and wheel assembly. Refer to "Tire
and Wheel Removal and Installation: ".
3. Release the wheel speed sensor wire harness
retainers and harness from the front brake hose.
4A-36
Advertisement
Table of Contents
Troubleshooting
