Table of Contents
Advertisement
1D-330 Engine Mechanical:
3. Install the EN 46106.
CAUTION
!
Refer to "Fastener Notice: ".
4. Install the remaining NEW engine flywheel bolts.
Tightening torque
1. Tighten the NEW engine flywheel bolts to 30
N⋅m (22 lb ft).
2. Tighten the NEW engine flywheel bolts an
additional 45 degrees using the J 45059.
Reference: "Crankshaft Balancer Installation: ".
Crankshaft Balancer Installation
Reference: "Crankshaft Balancer Cleaning and
Inspection: ".
Special tool
EN 46106 Engine Flywheel Holding Tool
J 41998-B Crankshaft Balancer Installer
J 45059 Angle Meter
1. The EN 46106 must be installed onto the flywheel.
2. Use the J 41998-B, nut, bearing and washer to install
the crankshaft balancer.
NOTE
Do not lubricate the crankshaft front oil seal
or crankshaft balancer sealing surfaces. The
crankshaft balancer is installed into a dry
seal.
3. Apply lubricant to the inside of the crankshaft
balancer hub bore.
Advertisement
Table of Contents
Troubleshooting
