Suzuki XL7 2007 Service Manual page 607

7. Observe the markings on the right cylinder head
camshaft bearing caps. Each bearing cap is marked
in order to identify its location. The markings have
the following meanings:
– The raised feature must always be oriented
toward the center of the cylinder head.
– The I indicates the intake camshaft.
– The E indicates the exhaust camshaft.
– The number 1, 3, 5 indicates the cylinder position
from the front of the engine.
8. Apply a liberal amount of lubricant GM P/N
12345501 (Canadian P/N 992704) or equivalent to
the camshaft bearing caps.
9. Install the camshaft bearing thrust caps in the first
journal of the right cylinder head.
10. Install the remaining bearing caps with their
orientation mark toward the center of the cylinder
head.
11. Hand start all the camshaft bearing cap bolts.
CAUTION
!
Refer to "Fastener Notice: ".
12. Tighten the camshaft bearing cap bolts in the
sequence shown.
Tightening torque
Tighten the camshaft bearing cap bolts in
sequence to 10 N⋅m (89 lb in).
13. Loosen the center intake camshaft bearing cap bolts
(1, 2) and the center exhaust camshaft bearing cap
bolts (3, 4).
14. Retighten the center camshaft bearing cap bolts (1,
2, 3, 4).
Tightening torque
Retighten the camshaft bearing cap bolts to 10
N⋅m (89 lb in).
Reference: "Camshaft Position Actuator Installation -
Right Side Intake (Third Design): ".
Reference: "Camshaft Position Actuator Installation -
Right Side Intake (Fourth Design): ".
Cylinder Head Installation - Left Side
Reference: "Cylinder Head Assemble: ".
Special tool
EN 46111 Crankshaft Rotation Socket
J 45059 Angle Meter
NOTE
Ensure that the crankshaft is in the stage one
timing drive assembly position using the EN
46111.
1. Ensure the cylinder head locating pins are securely
mounted in the cylinder block deck face.
2. Install a NEW left cylinder head gasket using the
deck face locating pins for retention.
Engine Mechanical: 1D-267