Suzuki XL7 2007 Service Manual page 939

Battery Negative Cable Replacement
Removal Procedure
NOTE
• Always use replacement cables that are of
the same type, diameter and length of the
cables that you are replacing.
• Always route the replacement cable the
same way as the original cable.
1. Remove the battery box. Refer to "Battery Box
Replacement".
2. Disconnect the positive and negative battery cable
clip (3) from the battery tray support bracket.
3. Disconnect the positive and negative battery cable
clip on the side of the battery tray support bracket.
4. Disconnect the negative battery cable electrical
connector (7) from the body wiring harness electrical
connector (2).
5. Disconnect the body wiring harness electrical
connector (4) from the battery current sensor (5).
6. Remove the negative battery cable ground terminal
nut from the wheelhouse stud.
7. Remove the negative battery cable ground terminal
from the wheelhouse stud.
8. Remove the negative battery cable ground terminal
nut (2) from the transaxle stud.
9. Remove the negative battery cable ground terminal
(1) from the transaxle stud.
10. Cut the tape and remove the negative battery cable
from the wiring loom.
Charging System: 1J-46