Suzuki XL7 2007 Service Manual page 419

4. Place the crankshaft balancer in position on the
crankshaft.
5. Thread the J 41998-B in the crankshaft. Ensure you
engage at least 10 threads of the J 41998-B before
pressing the crankshaft balancer in place.
6. Push the crankshaft balancer into position by
tightening the nut on the J 41998-B until the large
washer bottoms out on the crankshaft end.
7. Remove the J 41998-B.
8. Install the crankshaft balancer bolt.
CAUTION
!
Refer to "Fastener Notice: ".
9. Tighten the crankshaft balancer bolt.
Tightening torque
1. Tighten the crankshaft balancer bolt to 100
N⋅m (74 lb ft).
2. Tighten the crankshaft balancer bolt an
additional 150 degrees using the J 45059.
10. Remove the EN 46106.
11. Install the starter. Refer to "Starter Installation:
"Starter Installation.
12. Using engine support fixture, raise the engine into
position.
13. Install the engine mount. Refer to "Engine Mount
Replacement - Right Side".
14. Install the engine mount strut bracket. Refer to
"Engine Mount Strut Bracket Replacement - Right
Side".
Crankshaft Front Oil Seal Replacement
Special tool
J 29184 Oil Seal Installer
Removal Procedure
1. Remove the crankshaft balancer. Refer to
"Crankshaft Balancer Replacement".
2. Use a flat-bladed tool in order to remove the
crankshaft oil seal. Use care not to damage the
engine front cover or the crankshaft.
Engine Mechanical: 1D-79