Table of Contents
Advertisement
1G-54 Fuel System:
CAUTION
!
Do not bend the fuel tank straps. Bending the
fuel tank straps may cause damage to the
straps.
11. Support the fuel tank.
12. Remove the fuel tank strap bolts and fuel tank
straps.
13. Lower the fuel tank and heat shield from the
underbody of the vehicle.
14. If replacing the fuel tank, remove the fuel tank
module assemblies. Refer to "Primary Fuel Tank
Module Replacement" and "Secondary Fuel Tank
Module Replacement".
Installation Procedure
1. If previously removed, install the fuel tank module
assemblies. Refer to "Primary Fuel Tank Module
Replacement" and "Secondary Fuel Tank Module
Replacement".
2. Install the fuel tank heat shield and fuel tank
assembly to the vehicle.
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
3. Install the fuel tank straps and the fuel tank strap-to-
body bolts.
Tightening torque
Tighten the bolts to 25 N⋅m (18 lb ft).
4. Connect the fuel tank electrical connector and install
the electrical connector retainer to the rear frame.
5. Connect the EVAP vent, and fresh air hoses to the
fuel tank.
6. Connect the fuel fill tube to the fuel tank.
Tightening torque
Tighten the clamp to 5 N⋅m (44 lb in).
Advertisement
Table of Contents
Troubleshooting
